Tulsi Resin’s 3:1 – Art Epoxy for pouring your creativity.
| Specification | Value |
|---|---|
| Mixing Ratio | R:H – 3:1 |
| Pot Life At 25° C | 90 – 120 Min |
| Touch Dry | 8 – 12 hours |
| Fully Cured | 24 – 36 Hours |
| Measurement | By Weighing Scale |
| Viscosity At 25° C | 500 – 800 |
| Hardness | 75 Shore D |
| Properties | Description |
|---|---|
| Best For | Silicon Mould Casting, Deep Casting & Top Coat |
| Transparency | Crystal Clear with Glass like transparency. |
| Bubble-Free | Bubble get automatically busted after mixing |
| Wetting property | Uniformly spread to the surface, resulting in a smooth and even layer without any gaps, shrinkage or bubbles |
| Consistency | Thin consistency for easy mixing that also improve Mould’s life. |
| Features | Non-yellowing, Moisture Free, Hard Cure & Conforms to ASTM Rules |
| For Deep Pour | Description |
|---|---|
| Layer | 2nd layer pouring after 8-10 hrs. |
| Casting Thickness | Capable of casting up to 8-10 mm in a single layer. |
| Deep Pour | Capable of 2-3 inch (60 MM) deep pour in 6-8 layers. |
| Precautions | Guidelines |
|---|---|
| Application | Exercise caution in high humidity, low daylight, and low temperature conditions. – Maintain ambient temperature (20-35°C) and humidity below 65%. – Use vacuum to achieve air-free components in filled molds. |
| Mixing | Thoroughly mix manually or mechanically to eliminate haziness or streaks.- Mix small quantities to test your ratio |
| Safety | Wear personal protective equipment (PPE). – Avoid eye and skin contact; wash off with warm water if necessary. – Prevent inhalation of vapors, mist, or gas. Keep hardener bottle closed due to fuming tendency. |
Reviews
There are no reviews yet.